DownloadBedini energizer building manual pdf. Free Download 8 42 a. When ready, you should get a confirmation. Travis Outlaw – Amnesty Clause hey, my. REPLICATE THE BEDINI RADIANT CHARGING PHENOMENON .. BUILDING THE FRAME. UPDATED COIL WINDING INSTRUCTIONS BY LEE. . list of materials required to replicate the Bedini School Girl energizer. and testing the Bedini Monopole Mechanical Oscillator Energizer with Simplified that the beginner reads this manually thoroughly before starting to build.
|Published (Last):||18 October 2011|
|PDF File Size:||1.59 Mb|
|ePub File Size:||5.17 Mb|
|Price:||Free* [*Free Regsitration Required]|
So the coil is now pulling the south pole of thenext magnet towards it. This makes removing the rotor very easy for any changes. The first coil on the system has 5 wires all about feet long. That turnson the transistor and the coil is energized.
This is probably the bearings getting loosened up. But the ohm resistoris needed for each coil. The base is the switchwhich connects the collect to the emitter and allows the current to flow. The rotor should spin freely.
If it does not, check that there is not too muchpressure from the nut against the spacer. We put batteryclamps on the end of the wire and it is stripped bare on the other end to fit into the circuitterminal blocks like this.
You could evengo to 2 watts rather than 3 and it will still work. A wood shim works well. I have run mine many times on24 to 26 volts. On the top of theboard the fat housing of the 1N diodes insulates their leads from the ground bus. The connecting wires are just wires that go from the battery that powers thesystem and the wires that go to the battery or batteries being charged.
We like to color code the input and outputs. The other end of eachwire should have a battery clamp on it if you are running from a battery. Take the coil and place this spaceron the protruding part of the ferrite core.
See coil polarity on page On the collector or C leg the transistor is connected to the coil, the large outputdiode and a small neon bulb. Only on the 5 winding coil will these last two be connected to the coil. So it will workfine.
Here is a picture: With 4 magnets they will each be90 degrees apart and 5 magnets 72 degrees and 6 magnets is 60 degrees apart. Now touch the positive to the power source. On the left is a side view of the top. I have found that a 6 coil system with an increase bdini just 22 ohms in thetrigger resistor changes the current draw from 6 amps to 2.
Lincoln R60 welding rods work well. As the wire iswound on the spool it will require constant pressure to keep it even and tight. This system charges lead acid or gel cell batteriesin a unique manner.
If wedecrease it from its present value of ohms on the Kitty Hawk we can decrease thecurrent draw and it will use less power, but we also decrease the charging rate. The result is 11 better than the use of a skateboard manul. So the spacing is important not to be too small between eachmagnet or else the coil will start repelling the next magnet and slow everything down.
A one coil Kitty Hawkuses about 1. Refer to the picture on page 3 to see a system hooked up to the batteries. This system can use 11 to 24 volts reliably.
Then cut the sides of the notch down from thetop to the middle of the hole. Since the rotor and coil are already installed, just place a magnet with thesouth pole attached to the beidni end of the coil.