Category. Description, Digital Alarm Clock. Company, Sanyo Semiconductor Corporation. Datasheet, Download LM datasheet. Quote. Find where to buy. LM datasheet, LM circuit, LM data sheet: SANYO – Digital Alarm Clock,alldatasheet, datasheet, Datasheet search site for Electronic Components . datasheet search, datasheets, Datasheet search site for Electronic Components and LM Datasheet(PDF) 5 Page – Sanyo Semicon Device.
|Published (Last):||22 October 2005|
|PDF File Size:||9.55 Mb|
|ePub File Size:||7.46 Mb|
|Price:||Free* [*Free Regsitration Required]|
When my light bulb burned out with a bright flash due to a bad socket, it tripped the breaker for the whole circuit. Newer Post Older Post Home.
Digital Alarm Clock
Info on the code is no longer available. DrinkTea July 15, at Arrange it over the photo-sensitive PCB in such way that you can read the text normally through the transparency. The 50 Hz or 60 Hz pulses from the mains are used instead of an external oscillator, datahseet to keep things simple and thus cheap.
According to the datasheet, it it a 4-digit clock IC that uses a duplex LED display to show the time. It shouldn’t be too hard to use normal leds instead of a display. I have a small lamp plugged into the same circuit. That lasted a few days until the error code came back. This will prevent oxidation of the copper.
But they are fantastic clocks. You can also go with a 2 x 7. The chip can drive the LED display directly. The power supplied for each of the display segments is 18 mA.
A few days later, lm850 started to lose time, but kept running.
(PDF) LM Datasheet PDF Download – Digital Alarm Clock
These are great clocks and if my lamp had not damaged it, it may have kept running forever. Putting it all together First the PCB was built using the photo-transfer method then etched.
It also damaged my clock. You can leave pin 26 disconnected for 60 Hz, or leave it grounded to use it at 50 Hz with care, as ground is VSS here. I was lucky to find one in one of the scrap boxes. Before going further, there are a few things that need to be kept in mind when working with this chip: The schematic Since I was in need of a easy to read clock, I decided to make one with this chip.
This process is repeated fast enough that our eyes see the complete image.
(PDF) LM8560 Datasheet download
I played datwsheet with it a datashret more and it finally started keeping time again. From the time stamp, it looks to be made in the third week of I use one on my bedside table. Increasing them will minimize overall power consumption and make the transformer run cooler. I decided it was best to let it go, as the IC chip was most likely damaged. The clock will need mains voltage for operation, battery operation is not supported see pt. Fortunately there’s a simple fix available.
Regarding the display mode, the current build shows the time in military format 24H. I unplugged and replugged the clock until it finally displayed what looked like a 4-digit code.
Etching the board After thorough cleaning, I used a small piece of expended desoldering braid to cover the traces with solder. Parts soldered on the board. One disadvantage of this design is that the clock will only be as accurate as these oscillations are close to the rated value.
So when half of the display is on, the other half is off. The brightness of the display can be adjusted by changing R1 and R2 increase their value to make it dimmer. They are no longer sold and GE has no support for them anymore.
The only difficult part was finding a suitable display duplex LED, model S. Ready board The next step was to solder all the parts and find a cable to connect the screen. The maximum input voltage for the chip is V so make sure to use a suitable transformer. Without the backup battery, the time will simply reset.